Most garage conversions in Brentwood start with a two-car garage of about 20 by 20 feet. A foot or two either way changes what fits, so measure before you choose a layout.
1. Inside width and depth
Measure wall to wall at floor level, inside the studs or finished surface. Depth matters most: at about 22 feet deep a garage can usually take a bedroom, laundry and a full kitchen run along one side wall; shallower garages work better as a studio or a one-bedroom with the kitchen on another wall.
2. Ceiling height
Measure from the slab to the underside of the ceiling joists or rafters at the lowest point. Habitable rooms need at least 7 feet of ceiling height under the California Residential Code (R305). Garage slabs often slope toward the door, so measure at the back and at the door.
3. The garage door opening
Note its width and how far it sits from each side wall. The opening becomes a new wall, usually with a window or the entry door. Its position decides where the living room and entry go.
4. Walls shared with the house
For an attached garage, mark every wall the garage shares with the house and any door between them. An ADU needs a fire-rated separation there and the door is usually closed off; a JADU can keep interior access.
5. Existing windows and doors
Mark each one: which wall, how far from the corner, and its width. Keeping existing openings is cheaper than cutting new ones.
6. Distance to the property line
Measure from each exterior wall to the side and rear fences, and confirm the true lot line on your survey or the assessor's parcel map. Walls under 5 feet from a lot line must be fire-rated and can only have limited openings, which decides where new windows can go.
7. Panel, water heater and cleanout
Photograph the electrical panel label, the water heater and the sewer cleanout. They tell a designer how much power is available and how the new bathroom will drain.
Put the numbers to work. The MyADUPlan builder asks for each measurement, lets you tap the walls that touch the house and the door into it, and draws a floor plan from your numbers.